Offset pulley for 240 kit Indian Scout
Our payment methods:
Product number:
IS-OP
Product information "Offset pulley for 240 kit Indian Scout"
This offset pulley from NLC is needed for our 240 conversion kit for the Indian Scout.
Scope of delivery:
- Offset pulley
Indian Scout
Rear fender kit up to 240 tire Indian Scout
€599.00*
This steel fender was specially developed for a 240 tire and can be bolted to the original frame mounts plug & play. The original fender struts are reused here. We also offer the corresponding rear wheel rim and rear swingarm here in the store.
Scope of delivery:
Steel fender, unpainted
Fastening screws
TÜV sample certificate from an identical vehicle
TÜV information (for Germany):
A TÜV sample certificate from an identical vehicle is supplied for TÜV-Einzelabnahme. If you have any further questions about TÜV approval, please contact us.
Swingarm widening for 240 tires Indian Scout
€699.00*
We offer the widening of the original swingarm in order to be able to install a 240 tire in the Indian Scout. The original swingarm must be sent to us for this - it is then widened in a specially made welding gauge and then powder-coated. The spacers required for installation are supplied. This widening makes it possible to fit an 8.5 x 17 inch wheel (available to order here in the store) in the middle of the vehicle. It is necessary to order the corresponding offset pulley (also available here in the store).
Procedure:
Pack the original swing arm and send it to us (RF-Biketech GmbH, Mühlweg 10, 97720 Nüdlingen, Germany)
We widen the swingarm
The swingarm gets powdercoated again
We send the finished swingarm back to you
Scope of delivery:
Spacers for installation
Extended swingarm/frame axle
TÜV-sample certificate of an identical vehicle (for Germany) TÜV-Einzelabnahme
3-part custom wheel 8.5 x 17 Indian Scout
€1,695.00*
Surface inner part of rim:
black glossy powdercoated
|
Surface rim beds:
black glossy powdercoated
As the original rim of the Indian Scout cannot be widened, we have produced a 3-piece custom rim in the original design (Indian Scout Bobber). The rim can be installed plug & play in the rear swing arm that we have widened. The pulley offset has already been taken into account here so that the belt can run past the rear wheel in conjunction with the offset pulley (can be ordered here in the store). The rear wheel is supplied ready to fit, only the brake disk and ABS trigger disk from the original wheel need to be screwed on, the original shock absorber with pulley mount and pulley can still be used.
Scope of delivery:
Ready-to-install rear wheel, size 8.5 x 17, surface depending on variant
TÜV sample certificate of an identical vehicle for individual TÜV approval
Variants from €1,425.00*